Horizontal Slope For Shaking Table

المنتجات الساخنة

Physical and Computational Modelling of Geosynthetic-Reinforced

网页2022年11月5日Physical model tests in this study were carried out on a shaking table, which can produce horizontal base shaking with controlled frequency (1 to 50 Hz) and acceleration amplitude (0.1 to 2 g). The system can support testing of structures

Contact

Slope Stability Using Shaking Table SpringerLink

网页2022年4月7日Horizontal shaking table tests are carried on soil slope of two different angle and height by varying frequency as 2, 3 and 4 Hz with constant amplitude. As

Contact

Shaking Table Model Test to Determine Dynamic Response

网页2022年3月19日Dong et al. (2011, 2013) conducted a large-scale shaking table test on a bedding rock slope, investigated the failure mode of the bedding slope under dynamic

Contact

Shaking Table Model Test and Seismic Performance

网页2019年2月13日The shaking table model test, numerical analysis, and damage identification prove that this building is well designed and can be

Contact

Shaking table tests on the seismic response of slopes to near-fault

网页2022年4月15日Zhu et al. (2022) carried out shaking table tests to examine the seismic behavior of slopes located near-fault areas. Unidirectional and bidirectional earthquakes

Contact

Shaking table test for seismic optimization of soil slope reinforced

网页2022年3月1日For the first time, we carried out the shaking table test of new type EPS pile for soil slope reinforcement. We revealed the regional response characteristics of EPS

Contact

Shaking Table In Ore Processing Fote Machinery

网页There are several adjustments that need to be dealt with before using the shaking table. 1. Horizontal and longitudinal slope of the bed surface Make sure that the table slope is enough and the water flow is enough.

Contact

Shaking table tests and stability analysis of steep nailed

网页2011年1月25日The slope at an angle of 90° to the horizontal has a markedly lower seismic resistance than that at 80°. The rocking of the model slope was strong for the slope with inclined nails and the slope

Contact

horizontal slope for shaking table -- Vetura

网页2021年3月3日horizontal slope for shaking table. Mar 12, 2019 The dynamic response analysis of horizontal and inclined layered sites using large-scale shaking table tests in

Contact

Dynamic acceleration response of a rock slope with a horizontal

网页RESEARCH ARTICLE Dynamic acceleration response of a rock slope with a horizontal weak interlayer in shaking table tests Hanxiang Liu ID 1,2*, Tong Qiu3, Qiang Xu1,2 1 State Key Laboratory of Geohazard Prevention and Geoenvironment Protection, Chengdu University of Technology, Chengdu, China, 2 College of Environment and Civil

Contact

Shaking Table Model Test and Seismic Performance

网页2019年2月13日For this purpose, a shaking table test and its numerical analysis as well as structural damage identification were also conducted. This stone focuses on the investigation of the seismic behavior of

Contact

Effects of near-fault ground motions on dynamic response of

网页2021年10月1日Moreover, it is found from Table 5 that the horizontal PGA amplification factors with elevation are almost the same in Case 4 and Case 6. Dynamic response and dynamic failure mode of a weak intercalated rock slope using a shaking table. Rock Mech Rock Eng, 49 (2016), pp. 3243-3259. CrossRef View in Scopus Google Scholar

Contact

Shaking Table Modeling of Embankment Slope Response to

网页Shaking Table Modeling of Embankment Slope Response to Earthquake Loading Lin Yu-liang School of Civil Engineering, The angle of model slope was about 33.7° with horizontal.

Contact

Shaking Table Experiment of a Model Slope Subjected to a Pair

网页Berkeley. The table consists of an aluminum plate and beams bolted to two parallel horizontal tracks defining the direction of table movement. The horizontal tracks are anchored to an independent foundation to isolate the table from machine- induced vibrations. The shaking table is driven by a 22,000 kg,

Contact

Shaking table tests on the seismic response of slopes to near fault

网页We performed shaking table tests to investigate the effect of both horizontal pulse-like motion and vertical component on dynamic response of slope. Both unidirectional (i.e., horizontal or

Contact

An isolated similarity design method for shaking table tests on

网页2021年9月1日Shaking table test and dynamic numerical analysis are carried out to study the seismic behavior of the gravity retaining wall with anchoring frame beam supporting a steep rock slope (inclined at

Contact

Performance of Small Scale Model Slopes in Shaking Table Tests

网页The shaking table tests are conducted on small scale embankment slopes to study their behavior under dynamic conditions. Medium grained local sand with a water content of 3% is used in the study. The slope angle for the model slope is kept at 35 0 with three slope heights of 0.15, 0.18 and 0.21 m.

Contact

Damage Evolution of Rock Slopes Under Seismic Motions Using Shaking

网页2022年8月1日When the input horizontal motion is 4.46 m/s², the slope model fails and the damage degree reaches the maximum over 60%. mode and dynamic response of high slope using shaking table . test.

Contact

Shaking table tests on the seismic response of slopes to near

网页2022年4月25日We performed shaking table tests to investigate the effect of both horizontal pulse-like motion and vertical component on dynamic response of slope. Both unidirectional (i.e., horizontal or vertical motions) and bidirectional (i.e., horizontal and vertical components) motions are applied to soft rock slope model, and acceleration at

Contact

Shaking Table Model Test and Seismic Performance

网页2019年2月13日For this purpose, a shaking table test and its numerical analysis as well as structural damage identification were also conducted. This stone focuses on the investigation of the seismic behavior of

Contact

Shaking table test of comparison and optimization of seismic

网页2021年6月1日We carried out a shaking table test on a slope model reinforced by multi-anchor piles. By analyzing the characteristics of acceleration in time domain, we obtained the spatial position variation characteristics of acceleration particles represented by peak acceleration ratio (R a) and motion duration (B du).Based on Fourier variation and

Contact

Large-Scale Shaking Table Test of Seismic Response

网页2020年8月26日Based on the similarity theory, a large-scale shaking table test of a shallow double-arch tunnel under unsymmetrical pressure with a similarity ratio of 1 : 20 was designed and completed,

Contact

Response of High-Strength Rock Slope to Seismic Waves in a Shaking

网页2013年12月1日Liu et al. (2013 Liu et al. (,2014 conducted largescale shaking table tests on homogeneous and layered rock slope models. They found that the horizontal AAF increased with the slope elevation

Contact

Shaking Table Experiment of a Model Slope Subjected to a Pair

网页Berkeley. The table consists of an aluminum plate and beams bolted to two parallel horizontal tracks defining the direction of table movement. The horizontal tracks are anchored to an independent foundation to isolate the table from machine- induced vibrations. The shaking table is driven by a 22,000 kg,

Contact

An isolated similarity design method for shaking table tests on

网页2021年9月1日Shaking table test and dynamic numerical analysis are carried out to study the seismic behavior of the gravity retaining wall with anchoring frame beam supporting a steep rock slope (inclined at

Contact

Performance of Small Scale Model Slopes in Shaking Table Tests

网页The shaking table tests are conducted on small scale embankment slopes to study their behavior under dynamic conditions. Medium grained local sand with a water content of 3% is used in the study. The slope angle for the model slope is kept at 35 0 with three slope heights of 0.15, 0.18 and 0.21 m.

Contact

Damage Evolution of Rock Slopes Under Seismic Motions Using Shaking

网页2022年8月1日When the input horizontal motion is 4.46 m/s², the slope model fails and the damage degree reaches the maximum over 60%. mode and dynamic response of high slope using shaking table . test.

Contact

SPECTRUM CHARACTERISTICS OF STRATIFIED ROCK SLOPES USING SHAKING TABLE

网页By means of large-scale shaking table test, this stone analyzes the dynamic response of stratified hard rock and soft rock slopes with anti-dipping strata or dipping strata subject to strong earthquakes. The results show that: the seismic signal of the slope shoulder contains the characteristic of the slope structure and material. The processed signal using Fast

Contact

Shaking table tests on the seismic response of slopes to near

网页2022年4月25日We performed shaking table tests to investigate the effect of both horizontal pulse-like motion and vertical component on dynamic response of slope. Both unidirectional (i.e., horizontal or vertical motions) and bidirectional (i.e., horizontal and vertical components) motions are applied to soft rock slope model, and acceleration at

Contact